|
Every time you have to install turn fasteners, twist locks, common sense fasteners or lift-a-dots, this is what you hear. Cutting the holes, not too bad, but setting the fabric side with the washer and bending the four prongs, using a screwdriver blade or small hammer, someone always hurts their fingers or bends the prongs wrong. Design to hold the common sense fastener washer in place and bend the prongs in one operation. Turn the tool over and set all four prongs in one motion. This also works with lift-a-dot fasteners. The setting end can also be used to install turn fastener screw bases. The body of the tool is kurled “delrim” and all parts are case hardened steel, plated for a life time of use. Also included a carrying pouch that hooks onto your belt, so you don't misplace it. No more hurt fingers, scuffed fabric, cut fabric or broken prongs. No more having a hard time holding the washers. The bending and setting are done using your hands only, no hammer, maul, leather hammer or screwdriver needed, but can be used. You can turn the fastener base on the work fabric to set and not leave a mark. Cuts time, labor and wasted hardware.
|
