Self Piercing Die Instruction
will need to work the rubber retainer ring around the edge of the
grommet & washer.
To be certain they will be held in place properly.
Find the spot you want to
place the grommet in.
Apply pressure by squeezing the
You should feel or hear a slight
pop when the grommet cuts through your material.
After the grommet has cut through,
you want to adjust the pressure knob back slightly
to be sure the outside edges of
the grommet & washer do not cut through your material.
One more final squeeze
will set the grommet.
You will need to
experiment with the adjustment knob to find tune the tool for your
Back To Main
Back To Main Pres-N-Snap Page