Drapery Grommet Arbor Press 

Setting Instructions

Important !

Always securely mount your Press to a secure &

stable work surface with supplied bolts before you begin.

Step #1 - Back To Drapery Grommet Page

Insert top die into top of cutter.

 

Step #2 - Back To Drapery Grommet Page

Place Cutting Block, Fabric, Cutter & Top Die into Press

over the location of your hole

 

Step #3 - Back To Drapery Grommet Page

Position so the center shaft will come down in the center of the top die

Step #4 - Back To Drapery Grommet Page

Apply even pressure to cut through fabric.

You may repeat this process to cut all your holes.

 Step #5 - Back To Drapery Grommet Page

Remove top die & cutter

 Step #6 - Back To Drapery Grommet Page

Place Grommet Barrel side up on top of the bottom die.

 Step #7 - Back To Drapery Grommet Page

Place fabric on bottom grommet die and grommet and place into press

 Step #8 - Back To Drapery Grommet Page

Place washer, and top die on top of bottom grommet die, fabric & nylon block

 Step #9 - Back To Drapery Grommet Page

Apply even pressure to the center of the top die

Step #10 - Back To Drapery Grommet Page

With practice you will become a pro!