Your new setting machine has arrived without the handle installed for shipping purposes

You will need to remove the handle bolt located on the top front of you setting machine

After you install and tighten the handle bolt securely

It should look similar to the picture below

If you have purchased a Self Piercing Grommet and Washer set up

Proper setting die installation is pictured below

Spring loaded Grommet Die on Top, Washer die on bottom

Use your included Alan/Hex Wrench to tighten the top & bottom set screws

Please Be Advised:

Damage may occur to your setting machine if it is not properly secured to a bench or table top before use

If you have purchased a Self Piercing 4Pc Snap Die set up

Proper setting die installation is pictured below

In this View

Stud Die on Top, Eyelet Die on bottom

Use your included Alan/Hex Wrench to tighten the top & bottom set screws

                                                 Helpful Tips

In this View

Socket Die on Top, Cap/Button die on bottom

Use your included Alan/Hex Wrench to tighten the top & bottom set screw